HOWTO blindly setup networking
Lionel Lemarie - hikey@playstation2-linux.com
2002-05-24 v0.1

This document describes how blindly (or not) setup networking on Linux (for PlayStation 2)

- Turn your console on, if a TV is plugged properly you should see the Playstation 2 logo.
- Wait a good minute.
- Press the "return" key once, wait a second or two, and press the "return" key again.
- Wait.
- Be patient.
- After a while you will hear your hard drive stopping; or rather you won't hear your hard drive reading any more.
- From now on, be very careful what you type, you won't be able to see if you make mistakes.
- type "root" and press the return key.
- type the root password and the return key. Do not make mistakes.
- type "netconfig" and enter.
- It asks if you would like to set up networking. Press "enter".
- Press tab then type "192.168.0.9" (or whatever IP you want) and enter.
- Press delete 15 times (or more).
- Type "255.255.255.0" and enter.
- Press delete 15 times (or more).
- Type "192.168.0.1" (or the gateaway address if you know it) and enter.
- Press delete 15 times (or more).
- Press enter twice.

You're done, try ping it from a computer on the network.